|
Intruder Alarm Operating Instructions
Setting
and Unsetting the System
- Before
leaving the premises ensure
that all doors and windows are closed that there is no other person
remaining on the premises
- The
green day indicator should be
lit
- Press
the full set button to
activate the whole alarm, or part set to
activate the part set facility. The system will produce an
exit
bleep
tone you have 30 seconds to leave the premises via the prescribed exit
route
- On
entering the premises the system
will produce an entry bleep tone,
enter the four digit code the entry tone will stop & the green
day
indicator will illuminate. (on entering the premises you have 30
seconds to enter your code before the alarm activates)
- If
any zone or tamper indicator
illuminates then the alarm will have
activated and an intrusion may have taken place seek assistance before
investigating any further as intruders may still be on the premises
- To
omit zones:- enter the four
digit code press the OMIT button press
zone numbers to be omitted these indicators will now flash, press the
SET button to set the system (DO NOT ENTER ANY ZONES THAT HAVE NOT BEEN
OMITTED)
Contact the Alarm Engineer
if:
- The
red/green power light goes off
- The
tamper light illuminates. The
alarm system is protected by an
anti-tamper system. If any wiring, detector, keypad, the alarm
control-box and any device connected to the the alarm system is
interfered with, the alarm will be activated. The user can then reset
the alarm by entering the four digit code. The user will now be locked
out of the system and you must now contact the alarm engineer.
|
